Calibrated inspection equipment in use at our MIDC Talwade facility — listed with stated accuracy where documented.
Portable coordinate measurement for dimensional verification on the shop floor and at assembly stages.
High-precision length and height measurement for critical dimensional features.
Dimensional gauging and metrology instruments for in-process and final inspection.
Specialised measurement instruments supporting production QC workflows.
Fine height and step measurement for tight-tolerance machined and ground features.
VollMech applies a zero-rejection policy grounded in documented process control — not inspection after the fact alone. Statistical process control (SPC) monitors key dimensions during production so variation is identified before non-conforming parts accumulate. Poka-yoke error-proofing reduces setup and handling mistakes that cause dimensional drift. Kaizen practices drive structured improvement when recurring issues appear on the shop floor.
These practices sit within our ISO 9001:2015 quality management system, which defines how raw material qualification, in-process checks, final inspection, and release documentation are applied across precision machining, fabrication, and special assemblies departments.
Quality management system covering the production lifecycle — from material qualification through in-process inspection and final dimensional release — at our MIDC Talwade, Pune facility.
Minimum order quantities depend on part geometry, material, and setup requirements. Share your drawing and quantity targets via WhatsApp or phone — we respond within 24 hours with a project-specific assessment and quote.
Describe your project and documentation requirements. Our quality team will confirm what can be supplied for your scope.